User Registration In 1:1 Mode; Master's Authorization; User Id - Fermax FPAC-MAX Manual De Instalación

Cod. 970077b V04_21

4.3 User registration in 1:1 mode

In 1:1 mode, Mifare cards can be programmed with fingerprint templates only within AC-MAX
HW software according to the following procedure:
1. After establishing the connection with AC-MAX Fingerprint READER in the top menu of the
AC-MAX HW software, select the
2. Click the Format button
seconds, until the Formatted Card
Fingerprint Template tab,
3. Select the
the wizard.
4. Follow according to the displayed messages.
5. In AC-MAX software, register the user with the Add An Online Person Wizard by assigning
a card number with a pre-programmed fingerprint template.
6. Upload the configuration to the controller.
Note: In 1:1 mode do not set the FPAC-MAX FingerPrint READER in AC-MAX software, and do
not assign
users no fingerprint template in AC-MAX software.
Table 5. Maximum number of fingerprint templates on Mifare cards
Max number of templates
card
0
Ultralight
1
Classic 1k

4.3.1 Master's Authorization

In the last window of the card scheduling wizard it is possible to select the User
Authorization option.
identified in readers with the Accept Master Authorization
authorization is not related to the
software.
Note: Mifare cards have different capabilities. Mifare Classic 1k cards can store a fingerprint
template. Mifare Ultralight cards do not have enough memory to store any fingerprint template.

4.4 User ID

The identification of the user using the FPAC-MAX FINGERPRINT READER depends on the
recognition mode selected (section 4. 1.2), input with function
Reader Mode option
Card
identification method. In Table 6 below you can find more information about applying the input
with the [5] function. The Card
mode and allows permanent activation of the FPAC-MAX FINGERPRINT READER card reader.
When this option is selected, the user can be identified by cards or fingerprint templates, as
needed.
The ac-MAX HW options and functions allow for detailed and variable configuration of the user
identification method. But you can distinguish the following settings that are most commonly
applied:
•
1:N recognition mode, input [5] is not used, card reading mode
is only identified by fingerprint templates recorded in the memory of the FPAC-MAX FINGERPRINT
READER
•
1:N recognition mode, input [5] is not used,
user can be identified by the fingerprint template recorded in the memory of the FPAC-MAX
FINGERPRINT READER or by their Mifare card, as needed
Card Scheduler command
and place
the Mifare card near the reader for approximately 10
correctly message appears.
and then select the Save Template button
The user with this card does not have to scan the fingerprints when
Master Waiver,
(fig. 7). Input [5] is used for dynamic switching of the user
Reading Mode option is
and then the Card
option
which can be assigned to the user in ac-MAX
[5]: Card Reader Mode
applicable only for 1:N recognition
option
the Card Reading Mode option
Format tab.
to
start
with Master
enabled (fig. 7). This
and
disabled: the user
is enabled: the
11 | 16