Using The Memory Function; Deleting Measured Values - ProMed BDP-200 Instrucciones De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68
OPERATING THE DEVICE
When the measurement is completed, the systolic and the diastolic
pressure as well as the measured pulse frequency are displayed and
stored. Furthermore, the measurement result, with regard to the WHO
scale, is shown on the blood pressure analysis display (4). Now the
cuff allows the residual air escape from the system until it is completely
empty.
When the device is not used for more than one minute, it switches off automatically.
Note:
When the device determines during inflating that the pressure is not sufficient, it
automatically starts a new inflating process.
Note:
If the device does not stop inflating, press the Start/Stop button (A) which leads to an
interruption of the measurement and the immediate reduction of the cuff pressure.
Note:
DE
If it is necessary to abort the measurement for whatever reason (e.g. discomfort),
this is possible by pressing the Start/Stop button (A) at any time. This interrupts the
measurement and immediately reduces the cuff pressure.
EN

Using the memory function

This device has a memory for the storage of 40 measurements for each user. Each time a
FR
measurement is completed, the device automatically stores the blood pressure as well as the
pulse frequency. If 40 data sets have already been stored, the oldest measured values are
replaced by the new ones.
IT
Reading the measured values
Select the respective user by pressing the Set button (B).
By pressing the Memory button (D), you enter the memory menu.
ES
If no measured values are stored, the display only shows date and time.
Otherwise, the display shows the average of the last 3 measurements
and the symbol for average values (12).
NL
By pressing the Memory button (D) again, you can read the individual
measured values (the last value is displayed first, the first value is displayed last).
To exit the memory menu, press the Start/Stop button (A) and the device switches to the
RU
stand-by mode.

Deleting measured values

Select the respective user by pressing the Set button (B).
PL
By pressing the Memory button (D), you enter the memory menu.
By pressing and holding the Mode button (C) and the Set button (B) at
the same time, you delete all measured values of the selected user.
TR
Note:
Deleting of measured values cannot be reversed. Power tools, accessories and packaging are
AR
to be recycled in an environmentally friendly manner.
30

Publicidad

Tabla de contenido
loading

Tabla de contenido