Metabo BKH 400 Instrucciones De Servicio página 20

C Start machine and make first cut.
9.3 Insert cuts (U.K. users see para. 6.5)
Do not work without back stop. Danger of injury! Disconnect from power before fernicing.
9.4 Durchgehende Querschnitte mit Winkelanschlag
A Mount riving knife and saw blade guard
D Make cutting frequenceso that waste is to the left of the
A Remove riving knife and saw blade
guard. Tighten guard support plate.
B Install back stop block.
C Instructions
- Start machine only when fully set up.
- Place workpiece with your right hand against the back stop. Whith you left hand
push against the ripping fence and down into the blade.
D Important! Mark the area where the saw blade will cut through the work and keep
your hands at atleast 150 mm distance.
Danger of injury.
B Flip the mitre fence upwards and set
for the degree required.
blade.
C Pull back the mitre fence and place
the workpiece.
- Start the saw.