Porter Cable PCE380 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DUST EXTRACTION (FIG.11)
WARNING:
Always unplug saw
from power supply before any of the
following operations.
WARNING:
Never let the vacuum
hose interfere with the lower guard or
the cutting operation.
WARNING:
Do not use vacuum
when cutting metal.
• Connect dust extraction hose (19) to
extraction connection (13) and then
attach to your vacuum as shown in
figure 11.
11
19
GENERAL CUTS (IMPORTANT:
READ SAFETY WARNINGS AND
INSTRUCTIONS. )
GUARD AGAINST KICKBACK
With unit unplugged, follow all assembly,
adjustment and set up instructions. Ensure
the plunge mechanism returns to the locked
position in a timely manner. Select the
proper blade for the material to be cut.
• Measure and mark work for cutting.
• Support and secure work properly (See
Safety Rules and Instructions).
• Use appropriate and required safety
equipment (See Safety Rules).
• Secure and maintain work area (See
Safety Rules).
• With plug inserted and guard closed,
make sure switch turns saw on and off.
WARNING:
It is important to support
the work properly and to hold the saw
firmly to prevent loss of control which
could cause personal injury. Figure 3
illustrates recommended hand position.
OPERATION
ON/OFF SWITCH (FIG. 12)
• To operate the tool, first depress the
trigger lock and shoe release button
(10), then squeeze the on/off switch (1).
The tool will continue to run as long as
the trigger is depressed.
• To turn the tool off, release the on/off
switch (1). There is no provision for
locking the tool on, and the switch
should never be locked on by any other
means.
12
LASER LINE GUIDE
WARNING:
Never aim the beam at a workpiece with a
reflective surface. Bright shiny reflective
sheet steel or similar reflective surfaces
are not recommended for laser use.
Reflective surfaces could direct the beam
13
back toward the operator.
WARNING:
AVOID DIRECT EYE EXPOSURE. Do not
stare into the laser light source. Never aim
light at another person or object other than
the workpiece. Laser light can damage
your eyes.
WARNING:
glasses to enhance the laser light.
Tinted glasses will reduce overall vision
for the application and interfere with the
normal operation of the tool.
LASER SWITCH (FIG. 13)
• To turn the laser on, push forward on
the laser on/off switch (12a) to activate
the laser line (20) as shown in figures
13 and 14.
• To turn the laser off, push the laser
on/off switch (12a) back to the "OFF"
position.
13
12a
20
9
1
10
LASER RADIATION.
LASER RADIATION.
DO NOT use tinted
12

Publicidad

Tabla de contenido
loading

Tabla de contenido