Technical Data - Proxxon MICROMOT 60 Manual De Instrucciones

scope of delivery
1 pc. MICROMOT 60, E, EF drill/grinder
1 pc. Operating instructions
1 pc. Spigot nut with steel clamping jaw (nur
MM60, MM60/E)
1 pc. Drill chuck
Drilling and milling machine
Overview
legend
1. ON - OFF switch with speed control (MM
60/E-EF only)
2. ON - OFF switch
3. Power cable
4. Hook
5. Locking pin
6. Spigot nut with steel clamping jaw (nur
MM60, MM60/E)
7. 20 mm fitting for mounting in drill stand
8. Drill chuck
Description of machine
The PROXXON drilling and milling machine MI-
CROMOT 60/E/EF is the ideal tool for precise
drilling, milling, grinding, polishing, brushing,
rust removal, engraving, chasing and cutting.
For hobby electronics, model making, precision
mechanics, jewellery shops, opticians, arts, tool
and mould making.
For marking tools and cameras.
It can be used on steel, non-ferrous metals,
glass, wood, minerals and ceramics.
The drill spindle is supported in a precision ball
bearing which eliminates any play.
Excellent handling because of the pen-type
grip.
The machine is reliably driven by a high torque
motor. Type 60/E/EF is fitted with an electronic
speed regulator.

technical data

Length:
Weight:
Spindle collar:
- 18 -
approx. 220 mm
approx. 230 g
Ø 20 mm
Motor:
Speed (60/E/EF):
Voltage:
Power consumption:
Noise level:
Vibration:
Operation
clamping, changing tools
Attention:
• Never press the lock button while the device
is operating.
• Depending on the collet size, bits and cutters
may have a shaft diameter of max. 3.2 mm.
• Insert the tools are far as possible when
clamping. Ensure that the shaft of the tool
does not stand out more than 30 mm from the
collet. Excessively protruding shafts can
bend easily and contribute to poor concen-
tricity.
• Do not in any case use bits and cutters with
an arbour length of more than 55 mm!
• When using collets, always make sure that
the collet chuck and the utilised tool have the
same shaft diameter! The arbour of the tool
must be seated firmly and securely in the col-
let!
• Do not work with damaged, bent or worn bits
and cutters! Make sure the tools are in per-
fect condition. Damaged or worn tools can
break and cause injuries!
• When storing the bits and cutters, make sure
they are reliably protected from damage!
• A correct and consistent speed achieves a
high grinding performance, not excessive
contact pressure!
• By tendency: Bits and cutters with smaller di-
ameters require higher speeds than those
with a larger diameter.
• Attention: You absolutely must observe the
permissible maximum speed of the bits and
cutters! The tool can break when the maxi-
mum permissible speed is exceeded. Flying
parts can cause
5000 to 20 000 rpm
12 to 18 V
approx. 40 W
≤ 70 dB (A)
≤ 2,5 m/ s
2