Device Elements; Noise And Vibration Information; Intended Use; Technical Data - Würth 0891 110 640 Traducción Del Manual De Instrucciones De Servicio Original

Device elements

Overview [Fig. I]
1 Detachable tank
2 Air regulator
3 Air vent regulator and 8 bar safety valve
4 Nozzle cap
5 Nozzle holder
6 Union nut
7 Hanging eye
8 Nozzle regulator
9 Trigger lever
10 Handle
11 Air supply regulator
12 Compressed air supply R ¼" internal thread
13 Hollow space probe*
*Accessory (not supplied)

Intended Use

The device is intended for use in spraying bitumen,
rubber, plastic, synthetic resin and wax-based liquid
underseal/stone chip protection and hollow space
sealing products from special containers. The device
is intended for use with genuine Würth system acces-
sories. Any other use is considered an improper use.
The user is solely responsible for damage
resulting from improper use.

Technical Data

Art.
Air consumption
Working pressure
Max. pressure:
Recommended hose length
Min. inside diameter of the
hose
Air connection
A pressure reducer, a filter and a shut-off valve for
shutting off the air supply are required in the com-
pressed air system.
14
0891 110 640
200 - 300 l/min
3 - 4 bar
8 bar
10 m
6 mm
R 1/4" inside

Noise and Vibration Information

The equivalent continuous sound pressure level,
calculated on the A scale, is measured at a horizon-
tal distance of 50 cm. For bituminous products, this
level is <80 dB(A).
Operation (Fig. III)
Attention!
Dirty pipes could damage the device.
¾ Never tip the device through more than 45°.
¾ Do not close the device during use.
¾ After use, hand the device by the hanging
eye [7].
Connect the nailer to the compressed air supply.
■
Observe the technical data.
WARNING!
Danger due to pressure release
 The detachable tank [1] is under
pressure.
¾ Before the detachable tank [1] is
unscrewed, the safety valve [3]
must be turned clockwise to
release the contained pressure.
Unscrew the detachable tank in an anticlockwise
■
direction (Fig. 1/III).
Using a 1 litre bottle
Remove the safety cap from the bottle
■
Punch a hole in the safety aluminium seal of the
■
bottle using the vertical tube.
Position the bottle and tighten in a clockwise
■
direction (Fig. 2/III and 3/III).