Ryobi RHT-600R Manual De Utilización página 13

GB
F D E
SPECIFIC SAFETY RULES
During transport or storage, always cover the blade
■
with the blade sheath (6).
WARNING
NEVER USE THE TOOL WITHOUT THE
SAFETY GUARD.
LET THE TOOL WORK AT ITS OWN PACE.
DO NOT OVERLOAD.
ELECTRICAL SAFETY RULES
Make sure the cord is located so that it will not be
■
stepped on, tripped over or otherwise subjected to
damage or stress.
Connect the power lead to the mains only when no
■
one is handling the tool.
Do not abuse the power cord. Never carry the product
■
by the cord. Never pull the plug out of the power point
by the cord. Keep the cord away from heat, oil and
sharp edges.
For outdoor work use only suitable rain-water proof
■
approved extension cables.
Secure the extension cable by hanging it in the pull
■
relief (5) (Fig. 2).
Make sure there are no cuts, cracks or signs of
■
deterioration in the power cable. If any defects
appear, have the power cord replaced by an
Authorized Ryobi Service Centre.
A nameplate on the product indicates the unit's
■
voltage. Never connect the product to an AC voltage
that differs from this voltage.
If the power cord or extension cable becomes
■
damaged during use, disconnect the cord from the
supply immediately. DO NOT TOUCH THE CORD
BEFORE DISCONNECTING THE SUPPLY.
Adopt protective measures against electrical shock.
■
Avoid bodily contact with earthed parts such as metal
pipes, radiators, cooking ranges, refrigerators and
the like.
Electrical power should be supplied via a Residual
■
Current Device (RCD) with a tripping current of not
more than 30 mA.
MAINTENANCE RULES
Unplug the product before making adjustments
■
or repairs.
I P NL S DK N FIN GR HU CZ RU
English
Do not use the product if parts have been damaged.
■
Check the product regularly to make sure that it will
operate properly and perform the intended function.
Any part that is damaged should be properly repaired
or replaced by an Authorised Ryobi Service Centre.
Never douse or squirt the product with water or any
■
other liquid. Do not use detergents or solvents.
Wipe down housing with a damp cloth only, then dry
fully and make sure there is no debris remaining in
the blade or working parts.
Remove plug from socket before adjusting or
■
maintaining tool.
Always keep vent slits free of obstruction.
■
After each use, carefully clean the blade, rub over
■
with an oily cloth or treat with an environmentally
friendly lubricant.
SERVICE RULES
Service on this product must be performed by
■
qualified repair personnel only. Service or
maintenance performed by unqualified personnel
could result in injury to the user and/or damage to the
product. Such service may also void your warranty.
Use only identical replacement parts when
■
servicing the product. Follow the instructions in the
Maintenance section of this manual. Use of
unauthorized parts or failure to follow maintenance
instructions may create a risk of shock, serious injury
to the user and/or damage to the product. Such use
may also void your warranty.
When replacing the blade, the whole blade assembly
■
should be changed.
STORAGE AND TRANSPORTATION RULES
Stop the motor when you are waiting to cut or when
■
you are walking from one cutting location to another.
Store the product inside a dry place.
When transporting, disconnect the plug from the
■
mains. Carry the trimmer by the handles provided and
keep hans away from the cutting blade.
During transport or storage, always cover the blade
■
with the blade sheath, so that the blades aren't
accessible.
The knock-on protector can, if required, also serve as
■
a wall-mounted holder.
8
RO PL SLO HR TR EST LT
WARNING
Before carrying out any maintenance operations,
cut off the electric power supply by disconnecting
the plug from the mains.
LV SK BG