Dmx-512 Connection; Remote Control - Beamz Panther 25 Led Spot Manual De Instrucciones

DISPLAY

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal
(+) into a 3-pin XLR connector and plug this into the DMX output of the last fixture in the chain.

REMOTE CONTROL

With the IR remote, you can operate the moving head easy and you have many
functions.
To control the fixture you must aim the remote at the front of the fixture and be no
more than 30 feet away.
STAND BY - Pressing this button will blackout the fixture, the display of fixture
will be displayed STOP.
FULL ON - Pressing this button to fully light up the unit, the display of fixture will
be displayed UHI(white). Then you can operate the other steps of IR function.
GOBO - Pressing this button to enter Gobo mode. Use The 1-7 buttons to select
your desired gobo.
"DIMMER +" and "DIMMER -" – Press this button to adjust the out intensity.
STROBE - This button will activate the strobe Use the 1-7 buttons to select your
desired strobe
COLOR - Pressing this button to enter COLOR mode. Use the 1-7 buttons to
select your desired color.
SOUND ON & OFF - These buttons activate and deactivate the sound active
mode.(Sound mode must be operated under the show mode).
SHOW - This actives the show mode. Use the 1-7 buttons to select your desired built-in programs.
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode/Esc-button, browse through the submenu by pressing Up
or Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
You can leave every mode by pressing the Mode/Esc-button. The functions
provided are described in the following schedule.
5