ARDES AR4R09 Folleto De Instrucciones página 9

MOUNT THE SUPPORT WASHERS
Insert the washers into holes "C" and "D" in the metal supports and fasten them
with the nuts.
Turn the apparatus upside down and insert the bent end of the bracket into hole "A"
in the support (Fig. 1 and 2).
Place the support between the first and second element and fasten the bracket
(Fig. 3 and 4).
Insert the other threaded end into hole "B" and tighten the wing nut (Fig.5).
Mount the other bracket as described above, positioning it on the last element of
the radiator.
2
1
Before connecting or disconnecting the appliance, make sure that all the switches
are in the OFF position.
To turn the appliance on, insert the plug in the power outlet, select the relative
switch for the desired heat level and operate the room thermostat by turning the
knob clockwise.
The appliance is equipped with a knob that acts on an adjustable thermostat which
stops the flow of air once the set room temperature is reached; the flow of hot air
restarts when the room temperature drops.
This appliance does not require any special maintenance.
Disconnect the plug from the socket and let the appliance cool down well before
cleaning it.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from entering into
the apparatus and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
3
Maintenance
4 5
GB
9