UL STATEMENT
ETL listed 3074926
Conforms to ANSI/UL 60950-1-2002; Ed.:1
Certified to CAN/CSA-C22.2 No. 60950-1
FCC STATEMENT
Radio and Television Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet, prepared by the Federal Communications Commission,
helpful: How to Identify and Resolve Radio and TV Interference Problems. This booklet is available
from the U.S. Government Printing Office, Washington, DC 20402.
WARNING!
This equipment has been certified to comply with the limits for a Class B digital device under Part
15 of FCC Rules. This peripheral may only be attached to a computer certified to comply with the
Class B limits. Operation with a non-certified computer is likely to result in interference to radio and
TV reception. Any changes or modifications to this equipment not expressly approved by the
manufacturer could void the user's authority to operate this equipment.