X-LITE X-551GT Seguridad E Instrucciones página 16

- Should any of the side mechanisms fail or be damaged, please refer to an
X-Lite authorized dealer.
•
(Available as standard or accessory/spare part)
7 Inner Visor PINLOCK
7.1 Disassemble the visor (see instructions above).
7.2 DMake sure that the inner surface of the visor is clean and check that the pin
adjustment external levers are turned inwards (Fig. 7).
7.3 DPlace the PINLOCK
WARNING: The silicone-sealed profile of the PINLOCK
contact with the inner surface of the visor.
7.4 DInsert one side of the PINLOCK
it in position (Fig. 8).
7.5 DWiden the visor and fasten the other side of the PINLOCK
second pin (Fig. 9).
7.6 DRelease the visor.
7.7 DRemove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
7.8 DFit the visor on the helmet (see instructions above).
Checking and Adjusting the PINLOCK
Check the correct PINLOCK
and making sure that they do not move.
If the PINLOCK ® inner visor is not tightly fixed to the visor, move both external adju-
stment levers upwards to increase the stretch (Fig. 7). This operation must be carried
out gradually. The maximum stretch is achieved when the pin adjustment external
levers are turned outwards.
WARNING
- The presence of dust between the two visors may produce scratches on both
surfaces.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
it from moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors,
check that the PINLOCK
ched.
- An excessive and early stretch of the PINLOCK
excessive adherence against the visor surface and/or permanent deformations
with subsequent inability to correctly perform any following adjustments.
- Intense sweating /breathing, the use under particular weather conditions (low
temperatures, and/or high humidity and/or sudden changes in temperature
and/or heavy rain) and/or intense and prolonged use may affect the performan-
ce of the PINLOCK
tion. In such cases, after using the helmet and to restore the system efficien-
® Assembly
® inner visor on the visor.
® inner visor on one of the visor pins and hold
® Inner Visor Stretch
® inner visor assembly by opening and closing the visor
visors and inner visors may cause reduced visibility and
®
® inner visor is both correctly assembled and stret-
® inner visor and cause fogging or formation of condensa-
16
® inner visor must be in
® inner visor to the
® inner visor and check that the
® inner visor to prevent the
inner visor may result in
®