X-LITE X-551GT Seguridad E Instrucciones página 21

Chin Guard Air Intake:
ce visor fogging and formation of condensation. To close the chin guard air intake,
move the slider downwards (Fig. 19); to close it, move the slider upwards.
Side Extractors:
(Fig. 20).
Rear Extractor: it is integrated in a rear spoiler and allows warm and stale air to flow
out, ensuring optimum comfort inside the helmet (Fig. 21).
• N-COM - NOLAN COMMUNICATION SYSTEM PRE-SETTING
Your X-Lite helmet is factory-preset to be equipped with the N-Com communication
system.
During communication system installation (see the specific instructions contained in
the N-Com kit), it will be necessary to remove the foam material fillers located in the
polystyrene cheek pads next to the N-Com earphones seats.
WARNING
- The above-mentioned fillers should only be removed if the helmet is used with
an installed N-Com compatible system.
it allows conveying air in the mouth and visor area, to redu-
they allow continuous air recirculation in the mouth and visor area
21