Ariston CHAFFOTEAUX 3318591 Instrucciones Para La Instalación Y El Uso página 13

SYSTEM OPERATION CHECK
A straightforward test can be performed to
verify whether the system has been cor-
rectly installed:
- Press button .
- Check that the boiler is powered and
that the green LED on the receiver is
off.
- Press the button, the display will
visualise MAN.
- Press the "
set the room temperature value to its
maximum.
The boiler should switch on after a few
seconds and the symbol
pear on the display.
- Press button . The boiler will switch
off after a few seconds and the symbol
will disappear from the display.
(Remember to consider commutation
delay between the transmissions).
At this point, the installation procedure
should be successfully completed.
LOSS OF COMMUNICATION
If communication between the receiver
and transmitter is lost for roughly one
hour, the red LED on the receiver turns
on. When communication is restored, the
receiver will automatically start function-
ing in the normal mode and the red LED
turns off.
Temporary manual modifi cation
During loss of communication, the operat-
ing mode can be forced on the receiver.
Pressing the button on the receiver allows
for modifying the current relay position.
As soon as the transmitter sends a new
signal to the receiver, the latter starts
functioning in automatic mode.
The automatic check takes precedence
over the manual modifi cation.
RECOGNITION PROCEDURE
During the procedure, it is important to
keep the receiver and timer-thermostat at
least 1 metre apart.
To perform the recognition procedure, pro-
ceed as follows:
1. Press the button on the receiver for 15
" button and
2. Release the button.
3. Press the receiver button for 5 sec-
will ap-
4. Press the
5. Press OK to send the signal of connec-
seconds, the red LED starts fl ashing:
0.1 s on/0.9 s off.
NOTE: After 5 seconds, the red LED
starts fl ashing (0.5 s on/0.9 s off),
keep the button depressed.
onds to enter the connection mode.
The red LED starts fl ashing (0.5 s
on/0.9 s off) to confi rm that the con-
nection mode has been entered.
button, press buttons
together with the PROGRAM
button, the display will visualise
InSt and RELAY SIGNAL.
tion to the receiver.
The red LED turns off.
If the red LED continues to fl ash,
press the button again until the con-
nection is successfully completed.
GB
13