Eurosystems MFL01 Instrucciones De Uso página 23

DESCRIPTION (Fig.13)
n
Scything bar 6) Lever for the regulation of the side handlebar 7) Steel ring of the handlebar support.
n TECHNICAL DATA
Track: 430 mm. - Cutting bar width : 870 mm. – Total motor-mower length 1500 mm. – Total motor-mower height 1000
mm. – Wheels: (2) 13x5.00-6 – Mass: 60 kg. For further technical data and details for the engine, please see the enclosed instructions manual.
NOISE AND VIBRATION LEVEL
n
sound pressure level with En12733, Leq = 81,4 dB (A), with a uncertainty value K = ±1,1 dB (A). Handlebar vibration in compliance with EN 12733.
Level max detected = 10,39 m/s
n FAULT
Before performing any maintenance and clearing work operation , please take the spark-plug cap off.!
FAULT
The engine does not start
The engine power goes down
The grass cut is irregular
The cutting bar does not work or the wheels are not turning
In case you are not able to remedy the defect/damage according to a.m. table, please contact an authorized service center only .
1) Throttle control 2) Transmission control for driving wheels lever 3) Bar connection driving level 4) Engine 5)
Measured sound power level, Lwa = 94,2 dB (A), with a uncertainty value K = ±1,3 dB (A). Measured
, uncertainty value K = ± 5,19 m/s
2
.
2
FAULT CLEARANCE
check the fuel level, if necessary refuel.
check the throttle to be on START position
check the spark-plug connector to be properly attacched
check the spark-plug condition and if necessary replace it
check the fuel valve to be in the opened position (only for the models showing
such feature)
the air filter is dirty – please clean it
sharpen or replace the cutting blade
adjust the cutting bar clearance
adjust the cutting bar cable
check the wheels to be fasten to the shaft
check the position and the transmission belts position and condition : realign
position and/or replace them.
EN
23