Updating The Firmware - Gewiss JOINON Serie Manual De Instalacion Y Uso

Gewiss

12. Updating the firmware

Charging stations not designed for remote connection to the cloud platform can be updated using the microSD card in the relative slot of
the electronic board.
To understand which firmware version is installed in the device, just switch the station off and then back on again; the display will show
the version.
To update the firmware, proceed as follows:
#
1
2
3
4
5
6
7
80
Description
Disconnect the power supply to the product by means of the main device
Remove the microSD card from its slot on the electronic board
Insert the microSD card in the specific slot of your PC to open the folder
Paste the update file in the main folder of the microSD card
NB: contact GEWISS SAT Customer Service for the most recent file
Insert the microSD card in the slot on the electronic board
Power the product again to launch the automatic firmware updating procedure
Check the firmware has been correctly updated by verifying the release
version indicated on the display when the station is switched back on
Updating the firmware
7.55.4.515.2 - Installation and Operation Manual