Dmx-512 Connection; Master/Slave Operation - Beamz Illusion 1 Manual De Instrucciones

DISPLAY

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the
first unit in a DMX chain. Always connect the output of one unit with the input of the next unit until all units are connected.
5-pin XLR DMX Connectors.
Some manufactures use 5-pin DMX-512 data cables for DATA transmission in place of 3-pin. 5-pin DMX fixtures may be
implemented in a 3-pin DMX line. When inserting standard 5-pin data cables in to a 3-pin line a cable adaptor must be used.
The chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
At the last fixture, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-) and signal (+) into a 3-pin
XLR connector and plug this into the DMX output of the last fixture in the chain.

MASTER/SLAVE OPERATION

Master/slave operation
Fixtures in Show Mode can be linked in a chain and set to master/slave operation, where one master fixture running a
standalone show controls the behavior of slave fixtures. Two slave modes are available:
•
Fixtures in Slave 1 mode copy the master.
•
Fixtures in Slave 2 mode are synchronized with the master but have slight variations in behavior.
You must set all the fixtures except one as slaves. If you set more than one fixture in the chain to act as master, you may cause
damage that is not covered by the product warranty.
To operate fixtures in master/slave mode:
1. Link fixtures in a chain, using DMX cable to connect one fixture's DMX OUT socket to the next fixture's DMX IN socket.
2. In the MASTER SLAVE menu, set one fixture to MASTER and set all the other fixtures to SLAVE 1 or SLAVE 2.
3. Set the master fixture in the chain to run one of its four standalone shows.
4. Set all the fixtures in the chain to Slave 1 or slave 2.
USING THE CONTROL MENU
To access the control menus, press the MENU button. Navigate the menu structure using the ENTER, DOWN and UP buttons.
To select a menu option or to confirm a selection, press the ENTER button. To return to a higher level in the menu structure
without making a change, press the MENU button.
To exit the control menus completely, press and hold the MENU button.
4
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode-button, browse through the submenu by pressing Up or
Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
by pressing the Enter-button.
You can leave every mode by pressing the Mode-button. The functions provided
are described later in this manual.
3-Pin XLR Female (Out) 5-Pin XLR Male (In)
Pin 1 Pin 1
Pin 2 Pin 2
Pin 3 Pin 3
Pin 4 – Do Not Use
Pin 5 – Do Not Use