IMPORTANT! Before setting up tent, contact
Diggers Hotline (8-1-1) or a local authority to
verify that it is safe to set up tent in desired
location. Be aware of weather conditions, and
always evacuate tent during periods of high
winds or lightning.
1.
Ensure all parts are present before assembly. Lay
frame parts on ground in approximate locations
they will be when frame is assembled. (See Figure 1)
5'
7'
LG
EV
EV
HR
FR
EV
40'
FR
EV
FR
EV
HR
EV
PAGE 2 OF 24
Figure 1
LG
20'
EV
FR
HR
EV
FR
RG
EV
FR
RG
EV
FR
EV
FR
HR
EV
ASSEMBLY
2.
Place frame pins in 6-way crown.
a. Each protrusion on crown has two holes. The
alignment hole is closer to the center; the
placement hole is further down the protrusion.
(See Figure 2)
Figure 2
b. Place a pin in each alignment hole. Pin prevents
rafter from moving too far onto 6-way crown.
(See Figure 3)
Figure 3
Pin
3. Align two hip rafters (HR) with 6-way crown.
(See Figure 4)
Figure 4
HR
6-Way Crown
Alignment Hole
Placement Hole
Alignment Hole
HR
0721 IH-9236