Publicidad
Idiomas disponibles
Idiomas disponibles
13. Loosely fasten the alligator straps and attach to
canopy top at each side of the corners around
eave poles (EV) to secure tent top. (See Figure 19)
Figure 19
14. Attach base plates to legs and secure with frame
pin. (See Figure 20)
Figure 20
Frame
Pin
15. Lift downwind side of frame and keep all sides level.
Attach leg poles to the lifted side. (See Figure 21)
NOTE: Always lift the downwind side of tent first.
Figure 21
PAGE 5 OF 24
ASSEMBLY CONTINUED
Alligator Strap
Leg
Base
Plate
Wind
16. Raise other side of tent and attach remaining legs.
(See Figure 22)
Figure 22
17. Fasten the rest of the alligator straps around eave
poles (EV) by tugging on the excess strap to keep
the material taut and pulling the straps firmly. Slide
excess strap through the metal slide on the alligator
clip. (See Figure 23)
Pull to tighten.
CAUTION! Yanking on straps will cause undue
wear and tear as well as wrinkling of tent top
fabric.
IF USING STAKES (H-9236)
1.
Place stakes 5' out from each leg. Drive stakes into
the ground until 6" or less of the stake shows.
(See Figure 24)
Figure 24
Figure 23
0721 IH-9236
Publicidad
