Uline H-9236 Manual Del Usuario página 3

a. Slide hip rafters (HR) onto protrusion until they
meet pin. (See Figure 5)
Figure 5
b. Align placement hole in the crown with hole in
rafter and insert pin. (See Figure 6)
Placement
Hole
Figure 6
c. Remove alignment hole pins where hip rafters (HR)
are attached to crown. (See Figure 7)
Figure 7
4. Repeat steps 3b-3c to connect three full rafters (FR)
to the 6-way crown. (See Figure 8)
Figure 8
FR
HR
FR
PAGE 3 OF 24
ASSEMBLY CONTINUED
HR
FR
5. Beginning at a corner fitting, attach eave poles (EV)
to corner fittings and 4-way side tee fittings, working
clockwise around the assembly to complete the first
end bay. Attach to hip rafters (HR) and full rafters (FR).
(See Figures 9-10)
Figure 9
EV
EV
Figure 10
6. Repeat steps 2-5 to complete second end bay.
(See Figure 11)
Figure 11
Completed
Second
End Bay
FR
HR
Completed
First End Bay
0721 IH-9236