Attention to Installation
Lay upper drain hose
•
Needs a drain hose with minimum
diameter 3 cm, and minimum
carry away capacity of 40 liters per
minute.
For upper drain system, the drain
hose must be placed
Change the position of the
drain hose
The ex-factory installation position of
the drain hose is located the spin side,
According to the installation site, the
drain hose can also be installed at the
wash side of the machine . The
method is as follows:
1. Unplug the power cord and empty
water in the drain hose completely.
2. Spread a piece of soft cloth on the
floor (e.g. a blanket) and place the
washing machine on it gently.
3. Take the drain hose out from the
buckle at the spin side, and put it
into the buckle at the wash side.
4. Hang up the drain hose kit.
Frront
Blanket
Drain hose
Buckle
Installation site
In order to avoid electrical failure,
discoloration and deformation, do not
install the machine in the following
• Locations exposed
to direct sunlight
• Locations exposed to rain
or snow
• Locations with uneven
or unstable ground
33