Siefken SDS8 Instrucciones De Uso página 21

Mounting tool bits
Warning: before do it, make sure unplug the machine!
Warning: Always wear gloves when changing accessories. The exposed may become extre-
mely hot during operation.
Fig1
Fig3
Clean the shank of bit and put some grease
The assembly of bit without the shoulder(with groove) (see Fig 1 & Fig 2)
Operate the lock part 2 to Fig 1 position, insert the bit 1 into the holder 3.
Operate the lock part 2 back, pull the bit 1 to check if it was locked.
When disassembling, repeat operating lock part 2 to Fig 1, then pull out the bit from holder 3.
The assembly if bit with shoulder ( see Fig 3 & Fig 4)
The shank length can be 160mm(6 10/33 inch) (Length from shank end to the shoulder)
Operate the lock part 2 to Fig 3 position, insert the bit 1 into the holder 3.
Operate the lock part 2 to Fig 4 position, can lock the bit. Attention: The shoulder position
should be between lock part 2 and holder 3.
Operate the lock part 2 back, pull the bit 1 to check if it was locked.
When disassembling, repeat operating lock part 2 to Fig 3, then pull out the bit from holder 3.
Remarking: When you removing the accessory, such as a bull point, a cutter etc.., follow above
procedure in reverse order.
3 YEARS
Fig2
Fig4
L I M I T E D WA R R A N T Y
7