Maintenance And Inspection - Siefken SDS8 Instrucciones De Uso

3 YEARS
L I M I T E D WA R R A N T Y

6. Maintenance and inspection

Before do any maintenance and inspection, ensure unplug the plug.
1. Inspecting the tool
Use a dull accessory, such as bull point, cutter, etc., will cause motor malfunction and e ciency
degraded. Replace with a new one when your accessory is abased.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Any loose
should be tighten immediately, failure to do maybe cause serious hazard.
3. Maintenance the motor
The motor is the heart of the machine, please avoid any damage to the winding, or any water
and oil to wet it.
4. Inspecting the Carbon brush
Carbon brushes are consumable parts, when it becomes worn or "limit worn" it can cause
motor trouble. When an auto-stop carbon brush is equipped, the motor will atop automaticca-
lly.
Bring the power tool to a service center in good time so that the tool is always ready for use
when required.
5. Cleaning
Clean the machine regularly with a soft cloth, preferably after each use. Solvent such as gasoli-
ne, thinner, alcohol etc. These kind of chemical materials are not allowed to use; water or soap
are recommended!
6. Protecting the Environment
Do not dispose of power tools together with household waste material!
The machine, accessories and packaging should be sorted for environmental friendly recy-
cling.
In observance of European Directive on waste electrical and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of
their life must be collected separately and returned to an environmentally compatible recy-
cling facility.
8