Publicidad
Idiomas disponibles
Idiomas disponibles
A
6
1
Assembly with adjustable footrest (69003937044)
Fit the shift rod to the reverse gear change with M6x30 oval head screws,
7.5mm spacer ring and M6 flange nut at the drill hole (A).
NOTE:
For fitting the shift lever, see the individual adjustment of the shift lever.
Select the screw connection between the shift rod and the shift lever is such
that the angle between the screw connection.
C
D
Shift lever setting
Loosen the inner lock nuts (1). By turning the middle piece of the shift rod,
you can set the shift lever to the position that is most ergonomic for your
1
use.
When you have found the right position, tighten the inner lock nuts.
When you turn the middle piece of the shift rod, make sure that at least five
1
turns of the stud threads remain inside the middle piece.
Publicidad
