Foster EcoPro G2 Instrucciones De Funcionamiento Originales página 5

GB
Troubleshooting
Alarms/Warnings
Low temperature alarm
High temperature alarm
T1 Air probe failure
T2 Evaporator probe failure
T3 Condenser probe failure
#
only displayed if applicable to model and enabled through parameters.
Power Failure Warning
PF
' ' will be displayed, the alarm will sound and
that has affected the internal air temperature of the cabinet (only if the unit was not in standby mode).
When mains power is restored the cabinet will continue to operate, and adjust the temperature as required.
The warning will sound and show
would recommend the contents of the unit are inspected.
Before calling your supplier please make sure that:
a) The plug has not come out of the socket and the mains power supply is on i.e. is the controller
illuminated?
b) Check to see if the unit is in standby
c) The fuse for the cabinet is intact.
d) The cabinet is positioned correctly – cold or warm air sources are not affecting the performance
e) The condenser is neither blocked nor dirty
f) The products are placed in the unit correctly
g) Defrost is not in progress or required
If the reason for the malfunction cannot be identified, disconnect the electrical supply to the unit and contact
your supplier. When requesting a service call, please quote the model and serial number which can be
found on the silver label located on the inside of the unit (starts E.......).
Condenser clean warning
Condenser high temperature alarm
High pressure alarm
#
Door open alarm
#
Mains power failure
will show when there has been a mains power failure
until has been pressed and released, to cancel the alarm. We
#
#
#
#
#