Bradley SN2013 Manual De Instrucciones página 5

Installation
Rough-In Dimensions for Supplies and Drain
Notes
Maximum flow rate required to washfountain is 1 .5 GPM . Size supply lines
accordingly .
Supplies from Below: Stub up 2-1/2" (64) .
Supplies from Above: Supplies must be located on centers of dimensions shown to
pass through washfountain shroud and sprayhead .
Drain through floor: Stub up 3" (76) .
Supplies from Below or Through Wall
Type A
Off-line vent
(P-Trap supplied by
Installer .)
Top View
2-9/16"
(65)
6-3/4"
Optional Wall
(298)
7-15/16"
(202)
11-3/4"
(298)
12-1/16"
(306)
When running supplies and drain through wall, use same horizontal measurements as shown in Top View.
Position openings above the finished floor, at the following dimensions (to center):
Drain: Standard Height: 19-1/4" (305)
Juvenile Height: 15-1/4" (387)
Bradley • 215-923 Rev. M; ECN 17-00-002
Type H
Centrally rising vent -
passes through center of
unit (P-Trap furnished) .
11-3/4"
(298)
DRAIN
12-1/16"
(306)
18-7/16"
C
H
18-7/16"
(468)
Type B
Centrally rising vent -
passes through center of
unit (P-Trap furnished) .
6-3/4"
(298)
11-3/4"
(298)
(468)
Supplies: Standard Height: 12" (305)
Juvenile Height: 8" (203)
SN2013, SN2033 - Infrared
Key
1/2" Supply: Nominal Copper Tube
1/2" Supply Through Wall (Optional):
Nominal Copper Tube
1-1/2" NPT Drain
Supplies from Above
Top View
11-3/4"
(298)
Optional Wall
DRAIN
C
H
10-5/16"
(262)
11-1/2"
(292)
8/21/2017
(mm)
Type O
Off-line vent
(P-Trap supplied
by Installer .)
10-5/16"
(262)
11-1/2"
(292)
5