Safety Advice - BGS technic 1523 Manual De Instrucciones

GENERAL
This device allows adjusting the wheel camber after the disassembly of wheel bearings, shock
absorbers etc. By applying the water gauge to the wheel case you can determine and adjust the
suspension strut angle before the disassembly and after reassembly. Any further measurements of
the axle after maintenance are not necessary. This helps to cut back on expenses and expenditure of
time.
Range: 5° positive to 5° negative in 0.5° increments

SAFETY ADVICE

•
This manual is just brief information and will not replace a garage handbook.
•
Always consult specific service literature for repair, adjustments and check-ups. This way you
will avoid false diagnoses and wrong assemblies or adjustments that may harm your vehicle or
its components.
•
Any repair should be carried out by qualified personnel!
CALIBRATION
Calibrate the water gauge of this tool by using a
second, already calibrated water gauge.
Put the device straight up next to upright water
gauge and set the device's water gauge to
ZERO by using the calibration screw.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Magnetic Camber Gauge
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Camber is the angle between the level through
the wheel center and the lane vertical.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 1523