Lavorwash Skyvap Manual De Instrucciones página 55

triangular scrubbing brush, it is necessary to
connect the brush-joint (16) first:
- Keep the brush-joint pointed downwards and
insert it firmly into the brush. Then turn the brush-
joint upwards.
- Press the spring button (18) on the steam nozzle
handle (19) or on the extension pipe (17).
- Fit the brush-joint (16) into the steam nozzle
handle (19) or into the extension pipe (17), until
the spring button (18) snaps into place.
Removing the pipe or the brushes
• Push the spring button (18) on the steam nozzle
handle (19) or on the extension pipe (17).
• Remove the extension pipe (17) from the steam
nozzle handle (19).
• Keep the brush-joint (16) pointed downwards and
remove the brush from the brush-joint.
Protection cloth
(fig. F)
NOTE:
• Cotton cloths are used to protect surfaces from
scratches. Be careful! Cloths become hot while
you do the cleaning.
•WARNING!
• Change the cloth only after unplugging the steam
cleaner!
• Dirty cloths can be washed in the washing-
machine.
Applying the cloth to the scrubbing
brush
• Put the protection cloth on a plane surface.
• Lay the scrubbing brush (14) in the middle of the
cloth.
• Push the cloth holding spring clamps (15) and
keep them pressed.
• Put two corners of the cloth under the spring
clamps (15) from behind.
• Now put the front half of the cloth under the
spring clamps (15) and release them.
Applying the cloth to the triangular
brush
• Place the triangular brush (22) on the cloth (24)
• Wrap the cloth around the triangular brush (see
figure).
Fitting the small brush
NOTE:
• The small brush (21) must be used only together
with the bent nozzle (20).
- Fit the small brush into the bent nozzle.
- Fit the bent nozzle into the pipe (17) or into the
steam nozzle handle (19).
Cleaning window glass
(fig. G)
•ATTENTION! If external temperatures are around
the freezing-point, the window glass can be
slightly sprayed with steam at a distance of 20 cm,
at least.
• After that, you can treat the whole glass
surface with steam to offset sudden changes in
temperature and to avoid tensile stress on the
glass surface.
• Sudden changes in temperature between glass
and steam can break the glass.
Installing the glass cleaner - use
(7) Optional (fig G)
• Fit the window cleaner into the steam nozzle
handle (19) or into the extension pipe (17) until
the spring button (18) snaps into place.
NOTE:
• The regulator (12) features 5 adjustable positions:
on position 1, steam quantity is minimum,
whereas in position 5 it is maximum. Do not use
position 1 for more than 5 minutes.
• Very dirty windows must be cleaned first with the
small (22) or big (14) brush and the cloth (23 or
24).
• Then, clean the window with the window cleaner.
• After cleaning, remove dirt from the rubber head
of the window cleaner with a clean cloth. Only a
clean and well stretched band allows a perfect
cleaning of the window without leaving stripes.
- Spray steam onto the window starting at the top
and moving downward (fig. 1) by placing the
EN
55