Declaration Of Conformity; Technical Data; Noise/Vibration Information - Bosch PSR 14,4 LI-2 Manual Original

OBJ_BUCH-191-003.book Page 18 Tuesday, July 3, 2007 11:19 AM
18 | English

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 89/336/EEC,
98/37/EC (until Dec. 28, 2009), 2006/42/EG
(from Dec. 29, 2009 on).

Technical Data

Cordless Screwdriver
Article number
Rated voltage
No-load speed
– 1st gear
– 2nd gear
Max. torque for hard/soft screwdriving application ac-
cording to ISO 5393
Max. screw dia.
Max. drilling dia.
– Steel
– Wood
Chuck clamping range
Weight according to EPTA-Procedure 01/2003
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.

Noise/Vibration Information

Measured values determined
EN 60745.
Typically the A-weighted sound pressure level of
the product is 70 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Drilling into metal: Vibration emission value
2
a =2.5 m/s , Uncertainty K =1.0 m/s
h
Screwdriving: Vibration
2
a =2.5 m/s , Uncertainty K =1.0 m/s
h
2 609 002 432 | (3.7.07)
Dr. Egbert Schneider
Senior Vice President
Engineering
06.06.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
WARNING
according to
been measured in accordance with a standard-
ised test given in EN 60745 and may be used to
compare one tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to a significant un-
derestimate of exposure when the tool is used
regularly in such a way.
Note: To be accurate, an estimation of the level
of exposure to vibration experienced during a giv-
2
,
en period of work should also take into account
emission value
the times when the tool is switched off and when
2
.
it is running but not actually doing the job. This
may significantly reduce the exposure level over
the total working period.
Dr. Eckerhard Strötgen
Head of Product
Certification
PSR 14,4 LI-2 PSR 18 LI-2
3 603 J56 4.. 3 603 J56 3..
V= 14.4
0 – 370
rpm
rpm 0 – 1150
Nm 30/17
mm 8
mm 10
mm 30
mm 0 – 10
kg 1.35
The vibration emission level given
in this information sheet has
Bosch Power Tools
18
0 – 400
0 – 1250
36/22
8
10
35
0 – 10
1.45