Declaration Of Conformity; Starting Operation; Working Advice - Bosch Professional GSZ 160 Manual Original

OBJ_BUCH-465-001.book Page 13 Wednesday, October 10, 2007 12:19 PM

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
10.08.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly
Replacing the blade (see figure A)
Special blades are available for straight cuts and
curved cuts (accessory).
Press out the bolt 4 to the right or to the left in
order to remove the blade 1. Pull the blade 1 out
of the tool holder.
Slightly lubricate the bolt 4 and the blade to be
mounted 1.
Push the blade 1 into the tool holder so that the
borehole of the blade and of the tool holder cor-
respond to each other.
Push the bolt 4 through the boreholes until you
can hear it snapping in.
Bosch Power Tools
All manuals and user guides at all-guides.com
Operation

Starting Operation

Switching On and Off
To start the machine, push the On/Off switch 5
forwards.
To lock the On/Off switch 5, additionally push
down the front of the switch.
To switch off the machine, release the On/Off
switch 5. When the On/Off switch is locked, press
on the rear of the switch and then release it.

Working Advice

Apply the power tool to the workpiece only when
switched on.
Hold the power tool inclined in an angle of 15° to
the surface of the steel sheet and do not tilt it lat-
erally.
Guide the machine evenly and with light feed in
the cutting direction. Excessive feed significantly
reduces the service life of the saw blade and can
cause damage to the power tool.
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V can
also be operated with 220 V.
Wear protective gloves while working and
pay particular attention to the mains cable.
Sharp burrs develop at the cut steel sheet and
can cause injuries to the operator or damage
the mains cable.
1 609 929 M55 | (10.10.07)
English | 13
15˚