Technical Data; Replacement Of The Battery - Simu COLOR Manual De Instrucciones

GB Hz "COLOR" WALL TRANSMITTER
S.A.S. au capital de 5 000 000 - Z.I. Les Giranaux - BP71 - 70103 Arc-Les-Gray CEDEX - RCS GRAY B 425 650 090 - SIRET 425 650 090 00011 - n° T.V.A CEE FR 87 425 650 090
Hereby SIMU declare that this equipment "Hz color wall transmitter" is in compliance with the essential requirements and other relevant provisions of
directive 1999/5/EC. A declaration of conformity is available at the web adress : www.simu.fr, heading "Normes". Usable in UE ,
Programming the transmitter with an existing installation
1
Procedure for programming a new transmitter :
1.1 Open the memory of the receiver using its individual control transmitter :
PROG
or
1.2 Then validate the operation from the new transmitter to be programmed:
PROG
For group controls from the new transmitter, repeat operations 1.1 and 1.2 for each receiver of the group.
For main controls from the new transmitter, repeat operations 1.1 and 1.2 for each receiver of the installation.
To delete a transmitter from the memory of a receiver, perform operation 1.1 with a programmed transmitter, then per-
form the operation 1.2 with the transmitter to be deleted.
For more complete information about programming, please refer to the instructions of the receiver used.

Technical data

2
- Wireless switch/class III – Protection Index: IP 30
- Radio frequency: 433,42 MHz
- Ambient temperature of use : 5T40 (+5°C / +40°C)
- Storage temperature: 0°c to + 70°C
- Transmitter range :20m throught 2 concrete walls in nor-
mal pollution condition).
- Maximum transmission time: 10 seconds
- Power: 3V lithium battery typeCR 2430. Lifetime ± 3
years when 4 pressures of 1s. / day.

Replacement of the battery

3
2mm
1
63mm
STOP
PROG PROG
or
Press the Prog. key for about 1 sec. on the new transmitter, the motor
rotates for about 0,5 sec in one direction, then in the other.
3
2
1
Ø3mm
x 200 : 850364
or
PROG
- The Hz transmitters are compatible with: Hz receivers, The T5 Hz.01, T5
Hz.02, MSHz.01, DMI Hz.01, T5EHz motors.
- Keep away from children
- Do not recharge the battery.
- Do not position the transmitter near metal in order to
ensure its good working (reduced range).
- A radio appliance using the same frequency (for example :
hi-fi radio headphones) may deteriorate our product's per-
formance.
Read carefully these
instructions before any use.
2
"Program" key
Press the Prog. Key for about 3
sec. on the receiver's individual
control transmitter, the motor
rotates by about 0,5 sec in one
direction, then in the other.
Power supply is not required
for saving data. Data need
not be programmed once
again when the cell is chan-
ged.
Li
5013671D