Language; Password; Enable (Optional) - VERDER VP2-HT CL Manual De Instalacion Y Uso

LANGUAGE

PASSWORD

The password protects the modification of the Dosage, Utility and Relay menus.
It does not block Calibration and Set up.
First definition of the password:
Change password:

ENABLE (OPTIONAL)

The enable input (230Vac-110Vac) gives to the pump the consent to dose. In swimming pool plants this input is
connected in parallel with the recirculation pump power supply so that if the filtration is stopped the pump can not dose. In
order not to damage the electronic board, do not connect the enable directly in parallel with the recirculation pump power
supply, but always use a contactor / relay (see installation manual).
In the case that your pump has the enable option (see position B page 23: CONNECTIONS), you can choose to activate
this input or not.
Rev 1.1
In the Set up menu, select "Language" with the cursor and
press ENTER.
Choose "English" with the ▼ ▲ keys and press Enter.
If you want to esc programming and return to measurement,
press the ESC button for 3 seconds.
In the Set up menu, select "Password" by the cursor and
press ENTER.
Enter the password digit by digit selecting the number by ▼
▲ button and pressing ENTER.
After the selection of the 4th digit, press ENTER to save the
password. Take note of it carefully to not forget it. If it is not
possible to remember the password call the Customer
Service Assistance.
To esc programming and return to measurement, press the
ESC button for 3 seconds.
In the Set up menu, select "Password" by the cursor and
press ENTER.
Enter the old password digit by digit selecting the digit by ▼
▲ buttons and press ENTER.
After entering the 4th digit, pressing ENTER it is possible to
define the new password.
Enter the new password digit by digit selecting the digit by
▼ ▲ buttons and press ENTER.
After entering the 4th digit, press ENTER to save the new
password.
Take note of it carefully to not forget it. If it is not possible to
remember it, call the Customer Service Assistance.
If you want to esc the programming and return to
measurement, press the ESC button for 3 seconds.
Cod. 00.009.127 26