ASSEMBLY INSTRUCTIONS
Step 1:
Attach left upper side frame (A) and right upper side frame
(C) to left lower side frame (B) and right lower side frame (D)
respectively, using 1/4" x 13 mm bolts (AA). Tighten with hex
wrench (EE).
Hardware Used
AA
1/4" x 13 mm Bolt
EE
Hex wrench
Step 2:
Attach front top and middle stretchers (E) and back top
stretcher (F) between side frames (A, B, C and D) using
1/4" x 13 mm bolts (AA). Tighten with hex wrench (EE).
Hardware Used
AA
1/4" x 13 mm Bolt
EE
Hex wrench
Step 3:
Attach top panel (G) to left upper side frame (A) and
right upper side frame (C) using 1/4" x 35 mm bolts (CC).
Tighten with hex wrench (EE).
Hardware Used
CC
1/4" x 35 mm Bolt
EE
Hex wrench
v
1
Threaded sockets face
the same direction
C
A
x 8
AA
x 1
B
v
2
AA
C
F
x 10
x 1
E
A
B
v
3
G
x 4
A
x 1
CC
3
ASSEMBLY INSTRUCTIONS
Step 4:
Attach shelves (H) to side frames (A, B, C and D) using
1/4" x 28 mm bolts (BB). Tighten with hex wrench (EE).
D
Hardware Used
BB
1/4" x 28 mm Bolt
EE
Hex wrench
OPERATING INSTRUCTIONS
For stability, it is recommended you attach the unit to the wall. For instructions on how to attach the
unit directly to the mounting surface, refer to step 1. For instructions on how to attach the tipping
restraint hardware (FF), refer to step 2.
D
1. Adjust floor levelers to level the unit against the wall
where desired. Using back upper stretcher (F) as a
template, mark two mounting hole locations on the
wall. Drill two pilot holes into the wall where previously
marked. Make sure that the drilled holes can fit for the
wall anchors (sold separately) properly. Press the an-
chors into the holes and gently tap with a hammer until
flush in the holes. If the mounting hole coincides with
a wooden stud, there is no need wall anchor. Align
back upper stretcher (F) and back crossers (I) over the
anchors and insert M5 x 65 mm screws (DD). Tighten
securely with Phillips screwdriver.
Hardware Used
C
DD
M5 x 65 mm Screw
v
4
A
x 6
BB
x 1
B
v
1
Masonry/drywall anchor
not included
Wall
I
DD
x 2
4
C
H
D
F