Faucet Installation - Kohler K-15251 Guia De Instalacion

Valve
Stem
Undercover
Apply
plumbers
Inlet
putty.
Nut

1. Faucet Installation

NOTE: If your faucet does not have preassembled handles, the cold
valve stem is marked for identification. Left is hot, right is cold.
Place the undercover on the bottom of the faucet base.
Apply a bead of plumbers putty or other sealant to the underside
of the undercover according to the putty or sealant
manufacturer's instructions.
Center and align the faucet on the sink.
Securely hand tighten the nuts from underneath the sink.
Remove any excess putty or sealant.
2. Install the Handspray (optional)
Apply a bead of plumbers putty or other sealant to the underside
of the spray holder according to the putty or sealant
manufacturer's instructions.
Insert the spray holder through the sink hole.
Hand tighten the nut to the spray holder from under the sink.
Remove any excess putty or sealant.
Insert the handspray hose through the spray holder.
Attach the hose to the faucet base using thread sealant.
Kohler Co.
Spray Holder
Apply
plumbers
putty.
Apply sealant
tape.
Hose
3
Nut
1010457-2-B