Warning; Characteristics; Use; Description - VISIOMED BellCROSS VM-ET01 Manual Del Usuario

RISK OF INJURY
- Never push the trimmer to a depth greater than 0.5 cm in the nose or ears, as this could
damage the nasal mucosa or eardrum.
- Be sure to attach the cutting head properly for correct operation of the device.
- Do not use the clipper from the bottom up or sideways, this could cause cuts.

WARNING

- Do not use the device if any of its components are damaged or defective.
- This device is not intended for use by persons (including children) with impaired physical,
sensory or mental capabilities, or persons with no experience or knowledge of the device,
unless they have undergone supervision or prior instructions concerning the use of this device
by a person responsible for their safety.
make sure that the batteries are correctly installed. Damage occuring as a result of reverse
polarity will not be covered by the warranty.

2. CHARACTERISTICS

Multifunction nose, ears, beard and neckline hair clippers. Quickly removes unwanted hair.
High-precision blades made of high quality stainless steel. The light beam offers the user great
safety of use,''Brushed Steel'' waterproof finish.
• 1 electric hair clipper
• 2 interchangeable cutting heads
• 1 cleaning brush
• 1 storage unit
• User manual
• Warranty card
• Battery supplied (AA)

3. USE

3.1. DESCRIPTION

See diagram page 2
1
Protective cover
2
Cutting unit
3
Cutting head (nose and ear hair trimmer)
4
Integrated lamp
5
ON/OFF switch with on switch lock (transport lock)
6
Cutting heads (sideburns trimmer, beard shaping, neck line trimmer)
14 VM-ET01 - User Manual - 122016
Important
7
Clipper storage unit
8
Battery compartment

3.2. PRECAUTIONS BEFORE USE

For optimal use, make sure the device is clean. For better visibility, we recommend you face a
mirror while using the clipper.

3.3. SELECTION OF THE CUTTING HEAD

Make sure that the device is switched off when changing the cutting head. Rotate the
head counter-clockwise to disengage it from the base unit.
To fit the new cutting head, rotate the attachment clockwise and make sure that the arrow on
the cutting head faces the On/Off button.
Waterproof cutting head used to cut nose and ear hair with safety and
3
precision.
6
Waterproof cutting head used to trim sideburns, beard and trim neck line.
Slide the cutting head flat along the skin with no pressure, from top to bottom.

3.4. POWER ON/OFF

1. Remove the protective cover. 1
2. Select the cutting head or - See section 3.3 "Cutting head selection".
3 6
3. Push the On/Off switch up to activate the device.
5
4. You can start trimming your hair. The built-in lamp
5.Clean the clipper after use - see Chapter 4 "Device Maintenance".
VM-ET01 - User Manual - 122016
5
will guide you for better visibility.
4
15