CEMO KS 35-E Manual De Instrucciones página 8

GB
8. Installation
Mount the two rubber wheels
a. Pull out the rotor axle to its greatest extent (Fig 1).
a a
b. Turn the hopper assembly upside-down and
place onto a flat surface. Slide one metal
washer onto the axle.
Place a wheel onto the axle (Fig 2).
b b
c. Slide one end cap over the end of the wheel
hub and axle and secure in place by means of
one M5x45 bolt, locating the bolt through the
holes in the end cap, the wheel hub and the
axle (Fig 3).
c c
d. Repeat on the other side.
8
Assemble and mount the handle and
adjusting rod
a. Slide the adjusting rod through the hole in the
bracket at the top of the handle assembly (Fig 4).
d d
b. Turn the hopper assembly back into an upright
position. Insert the handle assembly into the
mounting on the back of the hopper (Fig 5).
e e
c. Insert the adjusting rod into the bracket located
below and to the right of the main handle
mounting (Fig 6).
f f