CEMO KS 35-E Manual De Instrucciones página 9

d. Secure the adjusting rod into place by means of
the two 2.5 x 22 split pins, one each at the top
bracket on the handle assembly and at the hop-
per mounting at the bottom, bending the pins as
shown in Fig 7 to lock them in place.
g g
e. Secure the handle assembly into place on the
hopper by means of one M8 x 30 bolt and nut
(Fig 8).
h h
f. Insert the T-bar into the top of the handle
assembly tube and fix into place with one
M 8x30 bolt and nut (Fig 9).
i i
each with 1 splint each with 1 splint
pin 2.5 x 22 pin 2.5 x 22
Attach the stay rods
a. Take one of the stay rods and note which end
has a large hole and which end a small hole.
By means of an M8 x 16 bolt, attach the end
with the large hole to the rear corner of the steel
frame on the hopper assembly (Fig 10).
j j
b. Repeat for the second stay rod on the opposite
side.
c. Align the small holes on the stay rods with the
hole through the main handle assembly.
Secure the rods to the handle with one M6 x 40
bolt and nut (Fig 11).
k k
The unit is
now complete
GB
9