Harman JBL ProCoustics MS-2 Manual Del Propietário página 4

DISTRACTION WARNING: Do NOT perform the setup procedure while driving. We recommend that
you perform these functions only after pulling off the road into a position that you are absolutely
sure presents no risk. Always obey all traffic laws while driving.
Setup Procedure for Systems Without an Aftermarket Powered Subwoofer:
IMPORTANT! We recommend always performing the setup procedure with the bass filter engaged (SUB
indicator off).
1. Connect the MS-2 as shown in the Connections section on page 2.
2. Enable your vehicle audio system's "Aux" (or MP3) input.
3. Set your portable audio player's volume level to its maximum level, turn off any bass boost or equalization you
may have enabled in your portable player's settings and play music on it. The MS-2's input indicator should light
green. If the input indicator flashes red, turn the volume of your portable player down until the red light stops
flashing and remember the setting. This is the volume control setting you should use on your portable player
while using the MS-2.
Set player
volume at maximum.
4. Adjust your vehicle audio system's volume control so the music is playing at a comfortable volume level. Adjust
the front/rear fader control so that the sound comes mostly from the front speakers but so you can still hear
some sound from the back. You can readjust this after setup.
4
0290CSK - JBL MS2 OM EN v1.indd 4
Input LED flashes.
5. As you sit in your vehicle's driver's seat, hold the MS-2 directly in front of your face, about 6 – 8 inches (150mm
– 200mm) away.
6" – 8"
(15cm – 20cm)
6. Press and hold the Setup button. The Setup indicators will flash one at a time and you will hear brief test signals
through your audio system's speakers. IMPORTANT: Do not move the MS-2 while the test signals are playing.
7. Keep holding the Setup button until one of the three Setup indicators remains lit, showing the setup results:
• OK: Setup has been completed successfully. The MS-2's DSP
equalization and time correction processing is now active.
• High: Your vehicle audio system's volume control was set too high
during the setup procedure. Lower the system's volume and repeat
steps 5 – 7.
• Low: Your vehicle audio system's volume control was set too low
during the setup procedure. Raise the system's volume and repeat
steps 5 – 7.
Press- and-hold
Setup LEDs
Setup button flash
You can repeat the setup procedure at any time. For example, if you want to re-tune the system for a different
listening position, simply repeat steps 5 – 7 while sitting in the new location. If you want to use the MS-2 in a
different vehicle, you will need to repeat the entire setup procedure (steps 1 – 7).
19/05/11 15:43:31