Daily Maintenance; Weekly Maintenance; Monthly Maintenance - MADER OTS550-6 Manual Del Usuario

1. Make sure wiring fuse and power supply are correctly installed.
2. Make sure all pressure and water are released from tank.
3. Turn on power switch. The pressure inside the tank will increase until it reaches
90-100 PSI. The system will then automatically shut down at this point.
4. Connect air tool and start the compressor to begin use. Note: Be sure to check
manufacturer's maximum pressure rating for air tools and accessories. Compressor
outlet pressure must be regulated to never exceed the maximum pressure rating of
the tool.
5. Use the regulator knob to control the amount of air pressure for the attached air
tool. Turn the knob clockwise to increase air pressure and counter-clockwise to
reduce air pressure.
6. To enable the best air pressure release and avoid air leakage, use Teflon tape to
wrap around hose and coupler thread.
1. Turn the power switch off after each use of the compressor.
2. Open the Moisture release drain value. underneath the tank and release all the air and
moisture inside.
3. The pressure gauge should now fall back to 0 PSI.
4. Release all air from the attached air tool, and the n disconnect hose from the quick
coupler.
WARNING! Before any maintenance or adjustments to your air compressor, always take
the following safety precautions:
1. Disconnect electrical power.
2. Open the Moisture release petcock to drain air tank of pressure.

DAILY MAINTENANCE

Before each use:
Be sure all nuts and bolts are tight
Check for any unusual noise or vibration
After use: open the air tank petcock to drain condensation from tank

WEEKLY MAINTENANCE

Clean air filter by opening air filter cap. Remove the filter element and clean thoroughly
with soap and water. Rinse thoroughly and allow to dry completely before assembly.

MONTHLY MAINTENANCE

Inspect air system for leaks by applying soapy water to all joints.
Tighten those joints if leakage is observed.
Check that all nuts and bolts stay tight.
STARTING THE COMPRESSOR
AIR RELEASE
MAINTENANCE
7