Makita HU01 Manual De Instrucciones página 15

For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
1 2
1. Crank
2. Undercover
3. Shear blades
010895
To install the grass shear blade, prepare the crank,
undercover and new grass shear blade.
1
010896
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1
1. Basic alignment line on the tool housing
2. Pins
010897
Adjust the three detent pin position so that these pins
are lined up at right angle in relation to the basic
alignment line on the tool housing.
3
1. Blade cover
2. Shear blades
2
2
1
2
010898
Fit the crank with its recessed part facing upwards onto
the detent pins. At this time, apply a small amount of
grease to the periphery of the crank using grease that
the shear blades as optional accessory are provided
with or that remains inside gear housing.
1
010899
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center
of these overlapped oval holes.
010900
Turn the shear blades upside down and install it so that
the detent pins on the tool fit in the hole in the shear
blades. Make sure that the shear blades are set in place
securely as far as they reach the base plate.
1
010901
15
1. Recessed part
of crank
3
2. Pins
4
3. Crank
4. Apply grease
1. Base plate
2. Hole in the base
2
plate of shear
blades
3. Oval holes that
are overlapped
3
1. Undercover
2
2. Locking lever