Home Decorators Collection 37960 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (FF) from the canopy (C) by turning
the ring counter clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (DD) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (EE) in the round
holes. This will enable you to remove the mounting bracket (A).
EE
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(GG) must be completely tightened.
NOTE: This fan is equipped with a safety tab (II). Should
the setscrew (GG) ever become loose while the fan is
running in reverse, the safety tab (II) will engage and
stop the fan from falling.
□
Loosen, but do not remove, the setscrew (GG) on the collar (HH)
on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (HH),
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (GG) on the collar (HH) on top of the fan-
motor assembly (E).
2
□
□
□
DD
A
C
FF
7
Routing the wires
Routing the wires exiting the top of the fan motor assembly
(E) through the center of the canopy ring (FF). Make sure the
slots on the canopy ring (FF) are on top.
Insert the ball/downrod (B) through the canopy (C) and slide
the decorative motor collar cover (D) onto the end of the
ball/downrod (B). Make sure the slots on the canopy (C) are
on top.
Route the wires exiting the top of the fan motor assembly (E)
through the downrod (B) as shown.
HH
Please contact 1-800-283-7048 for further assistance.
C
FF
B
D
E
C
FF
B
II
GG
E