Nextime 2999 Modo De Empleo página 5

ASSEMBLING:
• Step 1: Press out the die-cut shapes from the cardboard.
• Step 2: Color the outside of the box. Have fun!
• Step 3: Take the part (shown above) and gently fold back along the flaps.
• Step 4: Turn the cardboard around to view the reverse side.
• Step 5: Take the following parts pictured above.
Insert the cardboard cuckoo bird into pin.
Hook the S-hook underneath movement as shown.
Place 2 x AA batteries into the movement as shown.
• Step 6: Fold the box as shown
• Step 7: Fold side flaps as shown above and turn clock facing forward.
• Step 8: Fold the sides inwards as shown above.
• Step 9: Place the roof on top of the clock and fold the flaps into the small holes and press them into opening.
• Step 10: Fold the flap upwards and hang the pendulum on the S-shaped hook. Turn the clock around again.
• Step 11: Place the roof part and side parts in the holes on the side and on top as shown above.
Make sure they are firmly attached.
Cuckoo clock contents: Cardboard cuckoo house with hands and movement attached; cardboard roof; top part for roof; cuckoo bird+pin; S-form
hook; 2x side parts; pendulum.
OpErAtIONAL MANuAL:
tIME SEttING prOcEdurE (fIrSt tIME purchASE)
1. Insert 2 x AA batteries into the battery compartment
2. Turn the minute (long) hand clockwise by hand to correct time position, turn slowly and avoid touching the hour (short) hand underneath
• If the current time is PM (afternoon or evening), you should keep turning the minute hand until the hour hand pass "12" After this, you can set
the correct time position
• Select sound for the cuckoo by moving the switch located on upper left corner of the movement. Options are "WESTMINSTER" sound ,
"CUCKOO" sound or "OFF" no sound
• The sound is pre-set to turn off automatically from 10:00pm to 5:00am every day. First call at 6am, last call at 9pm
tIME SEttING prOcEdurE (fOr SItuAtION Of BAttEry chANGE, hANdS fELL Off frOM fIrSt purchASE, cuckOO SOuNd
dOES NOt ALIGN hOur)
If the hands are loose or fell off already when you open the box, follow the below steps to install the hands first
• Take off all other hand from the clock even if only one hand fell off; always pull the hands from the center location around the pole area, never
the tip
• Insert the minute (long) hand onto the pole of the movement, point it to "12"
• Insert 2 x AA batteries into the battery compartment
• Use your hand to slowly turn the minute hand clockwise until you hear a click sound then stop turning
• Remove the minute hand from the pole and take away the batteries also
5
User Manual – EN