BLACK&DECKER GL602 Traducción De Las Instrucciones Originales página 7

Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured in
accordance with a standard test method provided by EN 786
and may be used for comparing one tool with another.
The declared vibration emission value may also be used in a
preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
t
:
Warning! To reduce the risk of injury, the user must
O read the instruction manual.
Wear safety glasses or goggles when operating this
N tool.
E Wear ear protection when operating this tool.
Immediately disconnect the cable from the mains if it
R
is damaged or cut.
Do not expose the tool to rain or high humidity.
K
Beware of falling objects. Keep bystanders away.
L
Beware of sharp blades. Blades continue to move
after the motor is switched off.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the temperature may
u
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
u
40 °C.
Charge only using the charger provided with the tool.
u
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Do not damage or deform the battery either by puncture or
u
impact, as this can create a risk of injury and fire.
Do not charge damaged batteries.
u
Chargers
Warning! Your charger has been designed for a specific
voltage. Always check that the mains voltage corresponds to
the voltage on the rating plate.
Warning! Never attempt to replace the charger unit with
a regular mains plug.
Use your Black & Decker charger only to charge the
u
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
$ The following symbols are found on your charger:
The charger is intended for indoor use only.
Electrical safety #
Your charger is double insulated; therefore no earth
wire is required. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Never attempt to replace the charger unit with a
regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
ENGLISH
7