Philips HB 576/77 Manual De Instrucciones página 8

22
- Connect the connection cord to the solarium (fig. 22).
(To disconnect: fig. 23.)
- Insert the mains plug into a wall socket.
How to use
- Set the timer to the session
time (fig. 24).
(Please refer to the table in
these instructions and to
your own notes.)
- Do not forget to put on the
eye goggles provided.
25
- Push the solarium
backwards (fig. 25) so that
you can easily lie down on
the sun couch (fig. 26).
(With type HB 576 the place
for your head is on the right;
with type HB 577 this is on
the left.)
- When lying, pull the
solarium into a horizontal
position (fig. 27).
- As soon as the session time has elapsed the lamps will
automatically be switched off.
Cleaning
• Always unplug the Combi solarium and let it cool down
before cleaning.
• You can clean the outside of the Combi solarium with a
damp cloth. Make sure that no water runs into the
appliance.
• Do not use abrasives or scourers.
• Never use liquids such as alcohol, methylated spirits,
petrol or acetone to clean the protective plates as this
may cause irreparable damage.
23
24
0
26
27
Replacing the tube lamps and/or starters
In the course of time (in normal family use after some years)
the efficiency of the tube lamps will gradually decrease.
If this happens, you may increase the tanning session time or
have the tube lamps replaced.
• Have the tube lamps and/or the starters replaced by
authorized service personnel: they have the required skill
and the original replacement parts and tools to do the job.
They also have the facilities to dispose of the used tube
lamps.
Also the HPA lamp for face tanning (type HB 577) can only
be replaced by authorized service personnel.
The lamps of solariums and sun couches contain
substances which may pollute the environment.
f
When discarding old lamps, please ensure that they
are separated from the normal household refuse
and that they are disposed of at an officially
assigned place.
Fitting a different plug
This appliance is fitted with a BS 1363 13 Amp. plug.
Should you need to replace the plug, connect the wires as
follows:
Brown wire to the Live (L) terminal of the new plug.
Blue wire to the Neutral (N) terminal of the new plug.
Always fit the same value of fuse as that originally supplied
with your appliance. Only use BS 1362 approved fuses.
For your appliance this should be a 13 Amp. fuse (brown).
When disposing of an old plug (particularly the moulded type
which has been cut from the mains cord) always remove the
fuse as the plug could be dangerous if ever inserted in a live
socket.
8
For U.K. only: