Publicidad
Idiomas disponibles
Idiomas disponibles
Combi solarium does not operate as required?
If the Combi solarium should not operate as required, this may be due to a defect. In this case do not hesitate to apply to your
dealer or to a Philips Service Centre.
However, it is also possible that the appliance has not been installed according to the instructions or is used incorrectly.
If this is the case, you will be able to solve the problem immediately.
You may check the following section before contacting your dealer or Philips Service Centre.
Problem
• Combi solarium does not switch on.
• The power fuse switches the mains power
off when switching on or while using the
Combi solarium.
• The browning is not according to your
expectations.
Possible cause
- Mains plug is not in wall socket.
- No mains power. (Please check with other appliance.)
- Timer has not been set.
- Check the fuse to which the Combi solarium has been connected.
The proper type for your Combi solarium is a 13 A (for U.K.) or a 16 A (for
other countries) normal fuse or a slow reacting automatic fuse.
- You use an extension cord which is too long, wound-up and/or does not
allow the required power levels. Please apply to your dealer. In general,
we advise not to use an extension cord.
- You followed a course which is not the most appropriate for your skin type.
- The operational distance is larger than indicated.
- After using for a long time the UV production of the lamps decreases.
(With normal use this will not be noticeable for years.)
You may compensate for this effect by selecting longer treatment times or
replace the sun lamps
9
Publicidad
