Section Vi Maintenance - Wachs Q-Pon Cutter Manual De Instrucciones

SECTION V
3. Place tube in axial cutting position in vise with
tube extending just beyond the front edge of the
vise clamp. Proceed with axial cut (Figure 5).
Figure 5
4. Place the tube back into the radial cutting
position in vise with the tube positioned to
intersect the radial cut with the previous axial
cut (Figure 6).
Figure 6
SECTION VI
1. The TQ 1.0 has been designed to minimize maintenance. Clean
and inspect moving parts regularly for wear. Check power cord
periodically for damage or wear. Replace if cracked or damaged.
2. Replace blades at first sign of wear.
CAUTION: Worn cutting blades
are suseptible to slippage and
could cause serious injury.
Q-PON CUTTER
SETUP & OPERATING PROCEDURES
MAINTENANCE
5. Use the provided weld sample spreading pliers
to open up the weld sample for viewing
(Figure 7).
Figure 7
16
(CONT.)