Publicidad
1
1
2
NOTE: These faucets are designed to fit a maximum countertop thickness of 1".
Thick tile kit available as RP30392 increases thickness to 2 1/2".
SHUT OFF WATER SUPPLIES.
Remove nut, washer & paper tube from
A.
spout assembly. Set spout assembly
on sink making sure that gasket (1)
is properly aligned in cavity of base.
Mount spout on sink with washer and
nut (2). OPTION: If sink is uneven, use
silicone sealant under the gasket (1).
47136
Rev. B
B.
2
1
5
A.
2
Install Valve Assembly
Insert spout hose up through hole in sink. Slide
A.
the base then gasket (1) up over tubes of valve
assembly. Snap the end of spout hose (2) onto
the long quick connect spout nipple (3) facing
front of the valve. Pull down moderately to ensure
connection has been made. Feed tubes down
through hole in sink making sure that the gasket is
properly aligned in cavity of base.
1
Publicidad
