Promise Technology Pegasus J4 Guia De Inicio Rapido página 3

S
UMMARY OF SET UP PROCESS
This Quick Start Guide describes how to install four 2.5" storage drives in
the Pegasus J4*, then how to connect the power and Thunderbolt cable so the
device can be used and managed with a Thunderbolt equipped computer. The
installation steps in general are listed as follows:
S 1. I
TEP NSTALL HARD DISKS
S 2. C
TEP ONNECT THE POWER
S 3. M
TEP AKE THE
S 4. P
TEP OWER ON THE
S 5. C
TEP ONFIGURE THE
1
( 3) *
PAGE
( 6)
PAGE
T
HUNDERBOLT CONNECTION
J4 LED
AND CHECK THE
RAID *
ARRAY
*Note
There are two versions of the Pegasus J4 available, one is
shipped without any physical storage drives. For this version,
it is necessary to install four 2.5" HDD or SSD into the empty
storage drive bays to use the device and then confi gure a
fi le system on the drives. The other version is shipped with
drives installed and ready to use.
( 7)
PAGE
( 8)
S PAGE