Midwest Hen Haven Chicken Coop 62COOP Instrucciones De Montaje página 6

Install the Roof
14. Unscrew the plastic knob from each Roof Lock.
Insert the threaded part of the rod through the
hole on the inside of the Gabled Panel until it
reaches the outside of the Gabled Panel. The
spring will remain on the inside of the living area
and the short rod will rest inside the secondary
hole. Replace the plastic knob on the threaded
rod, on the outside of the coop. Repeat on the
other side.
Place the Bottom Roof Panel on the Coop by
15.
placing the Hinge Hooks in the Hinge Wires as
shown. The Bottom Roof Panel should be placed
on the Front side of the Coop.
16.
Place the Top Roof Panel on the Coop by placing
the Hinge Hooks in the Hinge Wires. The Top
Roof Panel should be placed on the back side of
the Coop. To lock the Roof Panel, pull gently on
Roof Lock knob until it engages with the steel
tubing on the underside of the Top Roof Panel.
Repeat on the other side. When unlocking, pull
gently on Roof Lock knob until it disengages, and
lift the Roof slightly to keep it disengaged. Then,
go to the other side and repeat with the other
lock.
Install the Ramp
17.
Open the Lift Top and guide the ramp toward
the back of the run so the clips will hook on the
wires of the Long Wire-Mesh Back Panel. From
the outside of the Coop, guide the hooks to the
appropriate wires so the ramp aligns with the
access hole in the Floor Tray.
6