Environmental Protection - BGS technic 11999 Manual De Instrucciones

IMPORTANT NOTES ON PERSONAL SAFETY
• Operate the tool using common sense.
• Always ensure a firm foothold, in order to be able to maintain your balance at all times.
• Do not reach through moving parts of the lifting tool.
• Always work with a second person present; in event of an accident, this person can call for help or
medical assistance.
• Do not use this tool if you are under the influence of medication, alcohol or drugs, or if you are tired.
Read the package insert of your medicine in order, to rule out an impairment of your judgement or
reflexes.
• Do not use the device if there is any doubt about the functionality of this tool.
• Always stay aware. During work, observe your workplace and carry out work with utmost care.
• Before use, check the tool for damage. If a part is damaged, use the tool again only after all
damaged parts have been repaired by an authorised specialist only.
• Do not use lifting tools for climbing, hanging or swinging. Misuse of the lifting tool can result in
serious injury.
• Only use the lifting tool on firm and level ground with a slope of less than 3%. Failure to do so could
result in the lifting tool tipping over and causing serious injury and property damage.
• Do not overload the lifting tool, pay attention to the max. rated load when setting the lifting arm
length.
• Lower and remove the load before moving the lifting tool.
• Use only slings or chains with a rated capacity greater than the weight of the load being lifted.
• Do not allow load to swing or drop violently while lowering or moving.
• Center load prior to lifting.
• Make sure that boom is fully lowered before adding oil to unit reservoir.
• Do not rock the vehicle while working on or around equipment.
• Equipment is design for lifting only, do not move or dolly crane when in use.
• Do not use this crane for any use other than the manufacturer specified usage.
• Failure to heed these markings may result in personal injury and/or property damage.
OCCUPATIONAL SAFETY
Always wear suitable protective equipment when using lifting tools.
Always wear anti-
slip safety shoes.
Wear a hairnet
when working with
machines that
have rotating
components.

ENVIRONMENTAL PROTECTION

Dispose of this product at the end of its working life environmentally.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment. Contact your local solid waste authority for
recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Always wear safety
goggles.
Wear a dust mask
if dust is raised
while working.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Always wear safety
work gloves.
Wear hearing
protection when
working with pneumatic
tools.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed