Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
INSTALLATION AND CONFIGURATION
PULSE METER WIRING
2b. Double channel pulse meter:
Connect the COM terminal (4) of the pulse meter
to the COM terminal (5) of the U•count electronic
board. Connect terminal "A" (6) of the pulser to
terminal "B" (7) of the U•count. At last, connect
terminal "B" (8) of the pulser to terminal "A" (9) of
U·count electronic board.
SOLENOID VALVE WIRING
In order to make the solenoid valve wiring, pass the cable
through one of the equipment cable glands, and then
connect both wires to the "S.V. OUT" terminal (10) of the
electronic board.
Once the equipment has been wired, mount the back cover
taking special care that the cables are not damaged and
adjusting their length if necessary.
4
838 849 R. 06/18
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
5
7
9
10
6
8
4
Publicidad
Tabla de contenido
